2.4 x 1.3in Timer Relay Module - Adjustable Trigger Cycle Timing & Delay Switch for Smart Home Automation, Electronic Experiments, and DIY Projects - Dual MOS Tube Control Board for Lighting, Appliances, and Industrial Equipment

Item Type: Timer delay switch circuit boardMaterial: PcbSize: Circuit board Approx. 60 x 34mm / 2.4 x 1.3inProduct Parameters:1: Working Voltage: 5-36V.2: Trigger Signal: (3,0 V-24V), with optocoupler isolation, can improve the anti-interference ability of the system (customers can also shorten the public ground).3: Output Power: DC 5V-36V, at room temperature, DC 15A, power 400W! Improve heat dissipation conditions, the maximum currentreaches 30A.4: Quiescent Current: 20mA; working current: 50ma5: Working Temperature: -40-85℃6: Optocoupler and insulation, greater anti-interference ability, industrial grade board.Note:The module has an active output, the output voltage is equal to the input voltage.2'DC+' and'charge+' are internal short circuits of the magnetic poles, but'DC-' and'charge-' cannot be shortened during use, otherwise the charge cannot be switched, and the equivalent charge carries electricity.The input voltage is large (5 ~ 36V), most of the equipment can be used, very convenient;The interface is clear and simple, powerful, easy to understand, and almost meets all your needs;Emergency stop function (stop key); under reverse polarity protection, reverse polarity will not burn the product.Increase the pause mode, if the mode is activated, there is no operation within 5 minutes, and then automatically turn off the monitor, any button can be activated;You can set different OP, CL, LOP parameters, these parameters are independent and automatically saved;After the module is closed, all parameter settings will not be lost.Way of working:P1: Trigger signal, the relay is at OP time and then disconnected; at OP time, as follows:P1.1: The signal is activated again and is invalid.P1.2: The signal is activated again and the clock restartsP1.3: The signal is activated again, the relay is closed, and the clock is stopped;P -2: Trigger signal, the relay is closed for CL time,